Havis-Shields WGI-D23-1 & 6 User Manual
Page 2
WGI-D23-INST-10-06
Mounting holes. Drill 1/8” holes.
Mount using #10 x ½” screws
INSTALL WINDOW GUARDS
• Loosely attach upper mounting bracket to window guard using ¼” x ½” tamper proof
screws and flat washers. (This step may already be done during shipping)
• Position screen to vehicle as shown in photo #2.
• Make sure you have the window guard centered on the door.
• Mark, drill 1/8” holes, and attach lower mount using #10 x ½” screws as shown in photo
#3.
Note: Be sure the upper mounting brackets go under weather stripping and the notches go
around the mounting plugs.
Make sure the mounting holes will have metal material to drill into.
• Press firmly against window guard and mark door where the upper mounting brackets are
located
• Drill 5/32” holes and mount to door using #10 x ¾” sheet metal screws.
Photo #3
Press firmly against guard until
bracket is under weather stripping.
Mark and drill 5/32” holes
Photo #2
Mount upper bracket using #10 x ¾” screws