Honeywell HCM-2051 - Manual (Page 4)

• Remove the water tank by grasping handle and
pulling straight up (Fig. 1). Set aside.
• Lift up on the motor housing to remove and set aside
(Fig. 2). Remove the Natural Cool Moisture ® filter
from the base before filling the unit with water. Soak
filter in a sink full of cool water to help reduce
mineral build up and place back in the humidifier
while wet. DO NOT SQUEEZE OR WRING OUT THE
NATURAL COOL MOISTURE
® FILTER. To help extend
the life of your filter repeat this step each time you
fill your humidifier.
• Turn the Water Tank upside down so that the Fill Cap
is facing up; unscrew the Fill Cap by turning it
counter-clockwise and set aside.
• Fill the Water Tank with COOL tap water (Fig. 3).
Distilled water is not necessary as the water is filtered
by the Natural Cool Moisture
® filter. DO NOT USE HOT
WATER. Doing so may damage the humidifier.
• Replace the fill cap by turning it clockwise . DO
NOT OVER TIGHTEN. Turn the Water Tank right-side
up.
NOTE: WHEN CARRYING THE FILLED WATER TANK
PLEASE USE THE HANDLE AND PLACE YOUR OTHER
HAND UNDER THE TANK FOR ADDITIONAL SUPPORT.
NOTE: We recommend that the humidifier be disinfected prior to first use. Please
see CLEANING instructions.
• Select a firm, level, flat location - at least six inches from any wall for proper air flow (Fig.
1). Place the humidifier on a water-resistant surface, as water can damage furniture and
some flooring.
The manufacturer will not accept responsibility for property damage caused by water
spillage
Fig. 1
Fig. 2
Fig. 3
W
ALL
6"
SET UP
FILLING
HCM-2051 OM (eng only) 6/25/01 1:40 PM Page 4