Hawking Technology HNAS1 - Manual (Page 6)

Front Panel
Power Button
To activate the Network Storage Center, press this Power button located on
the front panel of the device. To power off the unit, press the Power button
for two seconds until the Power LED starts to blink.
LED Definitions
Rear Panel
LED Status
ON /OFF Green/Dark Power
Boot/Shutdown: Blinking
Ethernet Connected Green
Ethernet Not Connected Dark
Link/ACT
Ethernet Data Transfer Blinking
HD Hard Drive Data Transfer Amber/Blinking
Reset Button
To restore the default settings,
use the tip of a ballpoint pen or
paper clip to hold this button
down for at least five seconds.
This will cause the default reset
to begin.
Ethernet Port
Use an RJ-45 Ethernet cable to
connect the device.
Power Supply
External power adapter:
DC 12V/3A.
6