HONDA Civic Remote Control Transmitter - Manual (Page 11)

11
Remote Control Code Programming
12
13
Press the "LOCK" or "UNLOCK" button on
the remote control transmitter.
• The power door locks cycle to indicate
programming mode.
• To terminate the programming mode at
this point, either turn the ignition key to
the "OFF" position or leave the remote’s
button untouched for over 10 seconds. To
program the remote, perform steps 2
through 12.
Press the "LOCK" button of each remote
(one at a line) to be stored in memory.
• The power door locks cycle to confirm
each entry.
• A button on each remote control
transmitter to be programmed must be
pressed. Perform the programming step
within 10 seconds for each remote or else
the programming mode will terminate.
Note:
Only 3 remotes can be stored in the system’s
memory.
12
13