Honeywell HS-160R - Manual (Page 3)

First look to see if your fan has a cross base or a round
base, and then follow the base assembly instructions for the
fan you have.
FOR CROSS BASE
• Place Base Extensions (A) as illustrated and push down
hard to snap Base Connector (B) firmly onto Base
Extensions (A) (Fig. 1).
• Insert the Metal Pole (C) into the Base by lining up the
recessed slot in the Pole to the raised dot on the Base
Connector and push in. Be sure that the Pole is fully
seated. Hold the Base firmly and twist the Pole
CLOCKWISE 90° until it stops. DO NOT OVER-TIGHTEN
(Fig. 2).
FOR ROUND BASE
• Insert the Metal Pole (C) into the Base by lining up the
recessed slot in the Pole to the raised dot on the inside of
Base and push in (Fig. 3). Be sure that the Pole is fully
seated. Hold the Base firmly and twist the Pole
CLOCKWISE 90˚ until it stops. DO NOT OVER-TIGHTEN.
SPEED BREEZE
TIMER OFF
TIMER SPEED 2 4 8 L M H
BREEZE
TIMER
SPEED
OFF
CLIPS
(G)
BLADE KNOB (F)
REAR GRILLE (E)
BASE EXTENSIONS
(A)
GRILLE
HUB
FRONT GRILLE
FAN BLADE
REAR GRILLE
MOUNTING
NUT (D)
METAL
POLE (C) BASE
CONNECTOR (B)
MOTOR HOUSING
MANUAL CONTROL
PANEL
REMOTE CONTROL
ASSEMBLY INSTRUCTIONS
Fig. 1
Fig. 2
C
B
A
RECESSED
SLOT
Fig. 3
C
RECESSED
SLOT
METAL
POLE
BASE
ROUND BASE CROSS BASE