Harbor Freight Tools SOLAR INSECT KILLER 95500 - Manual (Page 3)

Page 3 SKU 95500 for technical questions, please call 1-800-444-3353.
people with pacemakers should consult their physician (s) before using this
product. Electromagnetic fields in close proximity to a heart pacemaker could cause
interference to or failure of the pacemaker.
unpackIng
When unpacking, check to make sure that the item is intact and undamaged. If any
parts are missing or broken, please call Harbor Freight Tools at the number shown on the
cover of this manual as soon as possible.
aSSeMbly InStructIonS
note: For additional information regarding the parts listed in the following pages, refer to
the Assembly Diagram near the end of this manual on page 8.
Installation operation
note: The Solar Insect Killer with Light can be configured in two designs. One design is as
a Light that resembles a Lantern. The other design is a Solar Garden Light with a
stake that goes into the ground.
as a Solar garden light, insert the assembled Stake (17, 18, 19, & 20) into a
flat and level surface. Choose an area where the sunlight falls directly onto the
Solar Panel (2). Insert the sharp end of the Stake into the ground, deep enough to
hold firmly. Be sure you have avoided any underground wiring or plumbing. Attach
the Light firmly on the top of the Stake. See the cover photo. Make sure the area
is not accessible to children or pets and that the area has no plant debris nearby
that can fall on the unit.
as a lantern design, remove the Stake. You need to place the lantern in a area
where the Solar Panel (2) can be charged with direct sunlight while hanging. Lift the
Hook (1) and connect it to a chain or hook from a beam or door jam. Avoid hanging
it too low where bodily injury could happen. See Figure 3.
7.
1.
2.