Husqvarna 61 - Manual (Page 3)

English –
3
CONTENTS
Contents
Key to symbols .......................................... 2
Safety instructions
Personal protective equipment ......................... 4
Chain saw safety equipment ............................ 4
Inspecting, maintaining and servicing
chain saw safety equipment ....................................... 8
Cutting equipment .......................................... 10
How to avoid kickback .................................... 16
General safety precautions ............................ 18
General working instructions .......................... 19
What is what?
What is what? .................................................................... 24
Assembly
Mounting guide bar and chain ........................................... 25
Fuel handling
Fuelmix .............................................................................. 26
Fuelling .............................................................................. 27
Start and stop
Start and stop .................................................................... 28
Maintenance
Carburettor ........................................................................ 29
Starter device .................................................................... 30
Air filter .............................................................................. 31
Spark plug ......................................................................... 31
Muffler ................................................................................ 31
Adjusting the oil pump ....................................................... 31
Needle bearing maintenance ............................................ 32
Cooling system .................................................................. 32
Winter use ......................................................................... 32
Daily maintenance ............................................................. 33
Weekly maintenance ......................................................... 33
Monthly maintenance ........................................................ 33
Technical data
61 ...................................................................................... 34
268 .................................................................................... 34
Before using a new saw
• Read the instructions carefully.
• Check cutting equipment is correctly fitted and adjusted.
See page 25.
• Refuel and start the saw. Check the carburettor settings.
See pages 26-29.
• Do not use the saw until sufficient chain oil has reached the
chain, see page 14.
• Long-term exposure to noise can result in permanent hearing
impairment. So always use approved hearing protection.
IMPORTANT! If the carburettor mixture is too lean it greatly
increases the risk of engine failure.
Poor maintenance of the air filter will cause carbon build-up on
the spark plug and lead to difficult starting.
If the chain is badly adjusted it will cause increased wear or
damage to the bar, drive sprocket and chain.
Under no circumstances should you modify
the original design of the chain saw without
approval from the manufacturer. Always use
genuine spare parts. Unauthorized
modifications or accessories may lead to
serious injury or death.
!
A chain saw is a dangerous tool if used
carelessly or incorrectly and can cause
serious, even fatal injuries. It is very important
that you read and understand these
instructions.
!
WARNING! The insides of mufflers fitted with
catalytic converters contain chemicals that
may be carcinogenic. Avoid contact with
these elements in the event of a defective
muffler.
!
Long term inhalation of the engine's exhaust
fumes, chain oil mist and dust from sawdust
can represent a health risk.
!
Husqvarna AB has a policy of continuous product development
and therefore reserves the right to modify the design and
appearance of products without prior notice.