Haicom HI-203E - Manual (Page 28)

27
APPENDIX B
DEFAULT VALUES
The product has the following factory preset default values:
Commands can be issued to the HI-203E to change the settings of the
receiver. The new settings will remain effective on next power-on as long
as the on-board rechargeable backup battery is not discharged. After
the backup battery is discharged, factory preset default settings will be
used.
000 (WGS-84)
GGA ON
GLL ON
GSA ON
GSV ON
RMC ON
VTG ON
Checksum ON
4800 Bps
5 degrees
DOP Select: Auto
GDOP: 20
PDOP: 15
HDOP: 8
Normal Mode (without 1PPS)
Datum:
NMEA Enable Switch:
Baud Rate:
Elevation Mask:
DOP Mask:
Receiver Operating Mode: