Hampton Direct Katie Jig Appendix C - Manual (Page 3)

Page C-2 Copyright © 1997-2000 Hampton House, Inc.
Slide fixture toward bit
Determine height for pattern bit.
1/2" for guide forks
Base of router
table
Thickness of tail board
Trim stock or spacer At least 1/16" of bearing
must extend above base
of router table.
Pattern bit depth
Routing Pins and Tails
Grasp the router table handles on the side opposite the board that you wish to
route, and slide the KATIE JIG™ System toward the bit. Carefully route the
areas between each of the guide/tuning forks.
CAUTION: DO NOT lift the KATIE JIG™ System while the router is running!