Harbor Freight Tools Air Jitterbug Orbital Sander 90115 - Manual (Page 7)

Page 7
SKU 90115
Assembly Drawing
Maintenance
1
44
28
30
34
30
Warning! Disconnect the Sander from the air source before doing any maintenance.
1. Before each use check the sandpaper. If it is worn or torn, replace it.
2. Before each use apply a few drops of Pneumatic Tool Oil to the Lever pivot area.
See FIGURE 1 on page 5.
3. Wipe down the Sander after each use. Do not use solvents or abrasive chemicals to clean
the Sander.