Hearth and Home Technologies DM1242 - Manual (Page 2)

Hearth & Home Technologies Inc. • DM Doors • 31178 Rev J • 11/10 2
C. For All Installations
• Fold one pair of doors. Insert the pin into the large hole
located at the bottom outside corner of the fireplace
opening. Tilt it toward the center of the fireplace such that
the pins clear the top door track edge. Slide the pin into
the top door track until the pin snaps into the hole in the
spring clip.
• Doors may be adjusted by repositioning the spring clips
in the screw slots, by loosening the screws and then
retightening. Do not overtighten the screws!
• If removal becomes necessary, depress the spring clips
located in the upper corners of the fireplace and tilt the
doors towards the center of the fireplace opening.
Note: Glass doors aid in the prevention of loss of
room heat through an open chimney.
FULLY OPEN
CORRECT
PARTLY CLOSED
INCORRECT
PARTLY OPEN
INCORRECT
FULLY CLOSED
CORRECT
Figure 3 Proper Operation of Bi-fold Glass Doors
A. For Use on Reveal Series Appliances
• Door installation on the RBV4236 or RBV4842 requires
longer pins. The longer pins and screws to attach them
are located on the valve bracket of the appliance. See
Figure 1.
Figure 2 Install Pins
• Remove the shorter door pins using a phillips screwdriver
and replace them with the longer pins. See Figure 2.
Screws for DM Door Installation
Figure 1 Pins & Screws for DM Door Installation - Reveal
B. For Use on Odvilla-36, Odvilla-42
Outdoor Woodburning Fireplace
• Remove the screws from the door track area before
placing the door tracks on the fireplace. Once in place
reinsert screws.