haier T60-32 - Manual (Page 7)

Please make the machine stand horizontally.
Confirm that the washing machine is earthed reliably . Then insert the power plug I
nto the receptacle. Do not connect the earth terminal to the gas pipe and tap
water pipe.
Put down the drain hose .
Preparation before spinning
Spin process
1 Put the laundyies in properly
2 Put the gland in properly
3 Close the inner and outer coverof the spin tub
Select suitable spin time according to the laundries, and do spinning
Refer list 1 of page 3
4 Do you need water-added Rinsing-spinnning
Water-added rinsing-spinning has an effect that can remove the surplus liquid dirt,
5 Select spin time
Spin timer
Spin for about
1~2 minutes
1
OFF
2
3
4
5
Using sequence
Foam-removing
spinning
Remove most of
the foam extra
detergent liquid.
Remove the detergent
liquid remained
The effect is best when the laundries quantity is below 80% of the rated value.
Spin
Fill water for
about 1 minutes
Spin for about
1~2 minutes
Note:
Refer to the Notes on Spinning carefully.
6 Take the laundry out when the spinning ends.
When the spinning ends, open the top lid and the interior lid. Then take out
the depression cover and laundry after the spinning drum has stopped
rotation completely.
Note: If there needs no water-added rinsing-spinning , set the duration for
spinning directly.
Water inlet entrance
Water inlet hose
Install the water inlet hose
The water hose should be connected
as shown in the right figure.
It works in a way as follows: