Harbor Freight Tools 94241 - Manual (Page 6)

SKU 94241 For technical questions please call 1-800-444-3353. Page 6
Specific Safety Rules for the Hot House
1. Maintain labels and nameplates on the Hot House. These carry important information. If
the labels are unreadable or missing, contact Harbor Freight Tools for replacement.
2. Always place the Hot House on a dry, flat, level, sturdy non-flammable work surface
capable of supporting the weight of the Hot House and any plants or seeds. Make
sure to place the Hot House in a location that is out of reach of children.
3. Turn off the Hot House and unplug it from its electrical outlet before doing any
planting or maintenance.
WARNING: The warnings, cautions, and instructions discussed in this instruction manual
cannot cover all possible conditions and situations that may occur. It must be
understood by the operator that common sense and caution are factors which
cannot be built into this product, but must be supplied by the operator.
Unpacking
When unpacking your Hot House, check to make sure that it is intact and undamaged. If it is
damaged or broken
, please call HARBOR FREIGHT TOOLS at 1-800-444-3353.
Assembly-Using the Hot House to Germinate Seeds
Your Hot House comes completely assembled. You will have to supply seedlings (not included) and
set up the Mat, Tray, Seeding Container and Dome yourself. The Hot House must be unplugged
before adding any seeds or doing any work with it. It is important that you read the entire manual to
become familiar with the product BEFORE you operate the Hot House.
1. Place the Seeding Insert (2) into the Black Tray (3).
2. Decide on seeds and a growing medium such as garden soil or a soiless growing mix (all
not included). Information on the ideal mix to use can be obtained online or through your
local library.
3. With the Seeding Insert separated from the Black Tray (3) and Mat (4), fill each section of
the Seeding Insert (2) with growing mix.
4. Place the seeds individually into each section of the Seeding Insert (2). The seeds should
be placed into the growing mix according to the instructions provided on the packet along
with the seeds. Seeds can generally be covered to about three times the depth of the seed.
5. Moisten the growing mix.
6. Most seedlings germinate best if the soil temperature is around 75 degrees F. If soil is too
cold the seeds may not germinate. Seeds are done germinating once they sprout.
7. Placet the Transparent Dome (1) onto the Black Tray (3). Set the assembled contents (Black
Tray (3), Seeding Insert (2) and Transparent Dome (1) onto the Heating Mat (4).
8. Plug the Heating Mat (4) into a 120V GFCI outlet.