Harbor Freight Tools 67596 - Manual (Page 7)

Page 7 For Pressure Washer technical questions, please call 1-800-444-3353. SKU 67546/67596
For engine technical questions, please call 1-800-520-0882.
Set up instructions
Read the entiRe imPORtant
SaFetY inFORmatiOn section at the
beginning of this manual including
all text under subheadings therein
before set up or use of this product.
Risk of accidental starting;
resulting in serious personal
injury. turn the Power
Switch of the equipment to its “OFF” position, wait
for the engine to cool, and unplug the spark plug
wire(s) before assembling or making any adjustments
to the equipment.
note: For additional information regarding the parts
listed in the following pages, refer to the
Assembly Diagram near the end of this manual.
assembly
1. Operation of this equipment may create sparks
that can start fires around dry vegetation. A spark
arrestor may be required. The operator should
contact local fire agencies for laws or regulations
relating to fire prevention requirements.
2.
Brass Pump
Plug (14A)
Aluminum Pump
Breather Plug
(59A)
Dipstick (60A)
Figure 1
Replace the Brass Pump Plug (14A) with the
aluminum Pump Breather Plug (59A) and Dipstick
(60A) before first use. The Pump Breather Plug
must be used whenever the pressure washer is
used. The Brass Pump Plug (without the breather
hole) should be used for transporting only.
3. Attach the Handle (14) onto the Frame (17)
with the Handle Bolts (15) and Nuts (16).
4.
Outlet
Connector
(35A)
Water Inlet
Connection
Detergent Inlet
Connection
(26A)
Pressure Regulator Knob (44A)
Figure 2
Attach the Hose (18) to the Outlet Connector
(35A) on the unit (See Figure 2).
5. Pull the Collar at the end of the hose back
and attach the Gun (19) to the hose.
6. Screw the Wand (20) onto the Gun (19)
and secure with the grommet.
7. Choose the right Nozzle (5) for the job. Pull back
the quick connect collar and push the Nozzle
onto the end of the Wand. Make sure the quick
connect collar locks the Nozzle in place.
• Black Nozzle -
low Pressure
Used with pressure washer detergent.
• White Nozzle -
Wide Spray
Used to clean very large areas.
• Green Nozzle -
medium Spray
Used to clean larger areas.
• Yellow Nozzle -
narrow Spray
Used to clean small areas.
• Red Nozzle -
Pencil Spray
Only use on hard surfaces such as
concrete or metal. Can damage wood.
8. Connect the water supply to the Water Inlet
Connection on the Water Inlet Body (42A). The
water source must be able to provide a minimum
of five gallons of clean, cold water per minute
at 20 PSI. Only use a 5/8” inner diameter (or
larger) hose that is rated to meet this capacity.
if using detergent:
Read detergent directions. Connect one
end of the Detergent Inlet Hose (8) to the
Detergent Inlet Connection, and the other
end into the container holding the detergent.
Only use detergents specified for use with
Pressure Washers. The Pressure Washer will
draw one gallon of detergent for every seven
gallons of water. Only use the Black (low
pressure) Nozzle when spraying detergents.
WaRninG
Rev 11c