HONDA HRR216S3DA - Manual (Page 12)

Drive Clutch Lever (SD, S3D)
The drive clutch lever engages
(push forward) and disengages
(release) the transmission that
drives the rear wheels. The drive
clutch lever should only be
engaged after the engine has
been started.
Shift Lever (S3D)
The shift lever is used to select the
ground speed. 1 is the slowest,
and 3 is the fastest setting. The
shift lever may be used any time a
change in ground speed is
required.
Cutting Height Adjustment Levers
There are six approximate settings [3/4 ~ 3-1/4 in. (19 ~ 79 mm)]. The
adjusters move back to lower and forward to raise the mower deck.
For the best overall lawn finish, each wheel should be adjusted to the
same position.
3/4" (19 mm)
1-1/4 " (29 mm)
1-3/4" (41.5 mm)
2-1/4" (54 mm)
2-3/4" (67 mm)
3-1/4 (79 mm)
REAR ADJUSTMENT LEVER
FRONT
ADJUSTMENT
LEVER
RIGHT SIDE SHOWN
DRIVE CLUTCH LEVER (SD, S3D)
SHIFT LEVER (S3D)
CONTROLS
10