Hitachi M24SSD - Manual (Page 5)

16. Tension on the flow control lever may be adjusted
by tightening or loosening the tension nut as shown.
WARRANTY
EARTHWAY guarantees this product to be free of defects in origi-
nal workmanship and materials for a period of 90-days from sale to
the original user. If any defect develops during this period
EARTHWAY will repair or replace this product at no charge pro-
vided the defect is not the result of mishandling or tampering and
that this product is received at the factory with shipping charges
prepaid. For quicker service you may call EARTHWAY at 574-
848-7491 or write and describe the nature of the defect and we will
send repair parts to you. Due to the corrosive nature of most fertil-
izers and ice melters, EARTHWAY PRODUCTS, INC. makes no
warranty or guarantee against corrosion failure on models with
plated steel or painted steel frames. Clean your spreader well after
each use. Warranty covers parts only, but not labor charges.
OPERATING INSTRUCTIONS
Before filling hopper, become familiar with the operation of
this spreader.
Obtain proper setting for material to be used from the
RATE SETTING CHART included with this spreader.
Move stop bolt on rate gauge assembly to the proper
setting.
While pushing spreader forward, pull control lever back
to stop bolt.
To stop, push lever forward to close flow holes before
you stop moving.
When finished, empty any remaining material from hop-
per.
Thoroughly wash spreader and allow to dry before stor-
ing. No oiling is necessary.
HOW TO ORDER SPARE PARTS
All spare parts listed herein may be ordered direct from the
manufacturer, EARTHWAY PRODUCTS, INC.
Be sure to give the following information when ordering.
1. Model Number
2. Part Number
3. Part Description
Call (574) 848-7491 or write for current prices.
DO NOT RETURN TO DEALER FOR REPAIR
EARTHWAY PRODUCTS, INC.
1009 Maple Street
P.O. Box 547
Bristol, IN 46507
FOR YOUR RECORDS
_________________________________________
Date Purchased
_________________________________________
Store Name
PAGE 5
The settings furnished on the Rate Setting Chart are intended as a guide only. Variations in physical characteristics of material applied,
walking speed, and roughness of ground surface may require slightly different spreader settings. Due to the above conditions, EARTH-
WAY PRODUCTS, INC. makes no warranty as to the uniformity of coverage actually obtained from the settings listed.
17.
For normal operation both plates should
be fully opened. To reduce flow to the left
side, partially or completely close the plate
over the rear (large) hole. To reduce flow to
the right side, partially or completely close
the plate over the front (small) hole. Close
both plates for a narrow center spread pat-
tern. WARNING: If the optional side de-
flector is being used in the down position, the
plate over the rear (large) hole MUST BE
CLOSED or an over application of material
will occur.