Honeywell TE109NL - Manual (Page 7)

13
13
• Press MODE for the last time to return to the default mode (time of day
with seconds) after the last parameter is set.
CLOCK ALARMS
The Personal Weather Station has two time alarms – Weekday alarm (W) and
Single day alarm(S) - and one Ice Warning Alarm (PRE-AL).
• If Weekday (W) alarm is activated, it will sound at the set time and the
alarm icon will flash Mondays through Fridays
• If Single (S) day alarm is activated, it will sound at the set time and the
alarm icon will flash only for this specific day and will not activate on
subsequent days
• If Ice Warning Alarm ( PRE-AL) is activated, in will sound at the set
time and alarm icon will flash once the remote temperature for Channel
One (1) will reach 32°F(0°C) and below
NOTE: Ice Warning Alarm can be set only if one or both - Weekday or
Single alarm - are programmed.
SETTING THE WEEKDAY (W) AND SINGLE DAY (S) ALARMS
• Press ALARM ON/OFF button once to enter into the alarms setting
mode. The default alarm is a Weekday alarm (W). The abbreviation
“OFF” with a letter “W” next to it will be displayed, if the alarm has not
been set previously
• Press and hold ALARM ON/OFF button for two seconds. The hour
digit will flash
• Adjust the hour using UP ( ▲) or DOWN ( ▼) buttons
• Press ALARM ON/OFF button again. The minute digits will flash
• Adjust the minutes using UP (▲) or DOWN (▼) buttons
• Press ALARM ON/OFF button again to confirm and the weekday alarm
14
time will be set
• Set Single (S) day alarm if desired in the same manner
SETTING THE ICE WARNING ALARM (PRE-AL)
If Weekday (W) or Single day (S) alarm is set, the Ice Warning Alarm (Pre-AL)
can be programmed.
• Press ALARM ON/OFF button once to enter into the Ice Warning
Alarm setting mode. The abbreviation OFF with a PRE-AL next to it will
be displayed.
• Press and hold ALARM ON/OFF button for two seconds. The number
30 will flash, meaning that if selected, the alarm will sound 30 minutes
earlier than the Weekday or Single alarm.
• Select the desired Ice Warning Alarm interval in 15 minutes increments
between 15 and 90 minutes, using UP (▲) or DOWN (▼)buttons
• Press ALARM ON/OFF button to confirm and exit from the alarm
setting mode.
ACTIVATING THE ALARM
• Press ALARM ON/OFF button to enter into the desired alarm mode.
• Press UP (▲) to activate or DOWN (▼) to deactivate desired alarm.
When alarms are activated, the corresponding icons W, S or PRE-AL
will be displayed.
SNOOZE
When the time alarm sounds, press the SNOOZE button to temporarily stop it.
After the SNOOZE is depressed, the time alarm sound will resume in four
minutes. If the alarm is not disabled after that, it will sound for two more
minutes and then will stop by itself.