Harbor Freight Tools River Boat Wooden Model 90139 User Manual
Page 4
SKU 90139
PAGE 4
2.
Smooth the edges of the punched out pieces with sand paper. Begin putting together
by using the drawing below as a guide. Use glue on the portions shown in “black”.
See arrows in Figure D.
3.
Use Scotch Tape
®
on the backside to hold round or non-flat pieces together.
4.
A rubber band can be used to hold assembled pieces until glue has dried. Clean the
edges or surfaces of the Riverboat with a wet cloth to remove wet glue or
unsightly smudges.
5.
Rod “A” passes through Paddle Wheels and frame, left to right of the Riverboat.
6.
When assembly is completed, you can finish the Riverboat with paint, colored
markers or crayons using your creativity.
Figure E
#12
#27
#30
#29
#34 X 2
#32 X 2
#34 X 2
#9
#7
#6
#22 X 2
#2
#1
#5
#3
#37 X 2
#11 X 6
#36
#36
#18 X 2
#24 X 2 X 2
#25 X 2
#23 X 8 X 2
#19 X 2
#21 X 2
#13
#16 X 2
#17 X 2
#38 X 2
#40 X 2
#39 X 2
Figure D
#4
#10
Tape the underside
of the round to hold
together.
“A”
Brass Rod
#26
Put the rod through 19
and 20 assembly and
them put 23, 25 into 18.
Assemble #’s 26, 30,
31- 35 into #12
▼
▼
▼
▼
Assemble
Rod “A” through
#’s 21, 19, 23-25, 18,
17, 16, 13, left and
right.