Heath Zenith Wireless Chime TR-0095-RX - Manual

© 2007 HeathCo LLC 598-1171-03
This package includes (Style of push button and chime may vary from illustration):
• Wireless chime cover
• Wireless chime base
• Wireless push button w/battery • Hardware pack
You'll need to buy 2 “C” alkaline batteries for the chime. In typical use, alkaline
batteries will last up to one year.
Wireless Chime
TR-0095-RX
TYPE C
Battery Cover
Battery Cover
Catch
1. Install alkaline type A23 12 volt push button battery.
Remove back of case by pushing in tab on bottom with
a small screwdriver. Make sure battery is oriented
properly (see page 3).
2. Remove chime cover (see page 4).
3. Install 2 alkaline “C” batteries. Press in catch on
bottom of battery cover and lift to remove. Make sure
batteries are oriented properly.
TYPE
C
TYPE
C
1 2 3 4 5 6 7 8
4. Test range. Temporarily position chime and push but-
ton where you want them mounted. Press push button
to verify chime and push button work properly. If chime
does not sound, see Troubleshooting.
5. Mount push button. Use either screws or double sided
tape to mount push button.
• To mount with screws, remove back of case by
pushing in tab on bottom with a small screwdriver.
Attach back of case to door jamb or wall. Snap front
of push button on.
• When attaching push button using double sided tape,
make sure the surface of the door jamb or wall is
clean.