Hunter Fan 41545 User Manual
Page 25
25
41545-01 6/10/2002
®
PROBLEM
PROBABLE CAUSE
SOLUTION
Noisy operation (continued).
Excessive wobbling.
Note: When switching from medium
to low speed, you may notice some fan
wobble. When the fan stabilizes at low
speed, wobble will disappear.
4. Using non-approved speed control.
5. Glass screwed loosely to fixture.
6. Switch housing is loose.
1. Unbalanced blades.
2. Loose blades or blade irons.
3. Fan not secure on hanger assem-
bly.
4. Fan hanger ball not seated in
canopy tabs.
4. Change to approved speed control.
5. Hand-tighten the light fixture
screws. Ensure that rubber noise
isolators are installed.
6. Check and tighten screws to the
switch housing mounting plate and
to the upper and lower switch
housing.
1. Use balancing kit included with fan.
2. Tighten all screws.
3. Turn power off, support fan very
carefully, loosen canopy and hang
correctly.
4. Turn power off, support the fan
very carefully, and check that the
hanger ball is properly seated.
If you have tried these troubleshooting solutions and still have trouble, call 901-248-2222 or visit our
Web site at http://www.hunterfan.com.