HP Volume 23 - Manual (Page 9)

HP Multifunction Finisher (C8088A)
firmware revision: 031212_R
•
The paper path will now halt motors to avoid
ignoring a restart while ramping down with a
sheet of paper coming.
Changes have been made improving
performance with a single-sheet job. In
addition, the following issues have been
addressed:
•
Change to support noise and motor halting
problems to help printers running at a lower
speed.
•
Changes have been made to help address
certain scenarios that may cause 13.12.0D
and 13.12.02 jams.
•
The stacking tray moves down to a position
lower than specified when the accumulator
ejects sheets during a three-page print job.
In addition, the following issues have been
addressed:
•
The alignment plate moves forward during a
rear side adjustment when normal stacking
mode is set to OFFSET. •
When the stacker is detached, the printer
may hang while performing a media
autoflush.
•
The alignment plate does not open
appropriately before receiving the first sheet
during staple mode when media printed after
a long interval stacks on the accumulator.
•
When printing to the Face-Down bin using
long media (11 by 17 or A3), the pages start
to output to the Face-Up bin.
Stapler/Stacker (C8085A) firmware
revision: 031218_R
Control panel stuck at
CALIBRATING
•
Multiple changes have been made to
enhance auto-flushing after a jam condition.
•
Changes were made to send pages not
supported by the Face-Down bin to the Face-
Up bin.
Some printers, when powered-on, go through
the typical warming up procedure, but stop at
the message CALIBRATING. This also may
occur when the printer enters a calibration cycle
in the middle of a print job.
•
Changes have been made to help address
certain scenarios that may cause 13.12.13,
13.12.02, 13.12.25, and 13.12.0D jams.
To troubleshoot this problem, follow the steps
below: •
The paper offset for A4 paper size in
landscape orientation and A3 paper size has
been reduced to a half-inch.
1 Open the printer’s front doors and lower the
green handle.
In addition, the following issues have been
addressed:
2 Open the printer’s right (ITB access) door
and remove the ITB.
•
Landscape-oriented documents are stapled in
the wrong location.
3 Locate the black plastic shutter that covers
the calibration sensor.
•
TOO MANY PAGES TO STAPLE does not
clear from the control panel without a power
cycle.
•
When printing to the Face-Down bin using
long media (11 by 17 or A3), the pages start
to output to the Face-Up bin.
Stacker (C8084A) firmware revision:
031211_R
•
Speed for ejecting the paper to the Face-Up
bin has been increased to keep pages from
being pulled below the exit roller.
Calibration sensor shutter
HP Color LaserJet 9500 printer updates 9