Havis-Shields C-VS-1000-TAH - Manual (Page 4)

C-VS-1000-TAH-INST-1-07
Carefully drop backside of
console as shown
Install lighter plugs and extend
wires as necessary.
Slide C-VS-1000-TAH, front side
first, as shown above.
#15 #14 #13
#20
Align rear-mounting studs into
factory console holes and attach
using ¼” Serrated nuts.
Re-attach factory plug into
switch box
Be sure plug is secure and
wires are carefully routed so
not to chafe
#18 #17 #16
Route all wiring to console. Wire,
and install control heads and
accessories (Sold separately)
Attach middle of VS console to factory console
using ¼” x ¾” Hex bolts and serrated nuts. For
added support #10 x ¾” screws can be installed
on front side of console
#19 For added
support install
#10 x ¾” screws