Havis-Shields 1996-2006 Ford Taurus C-TCB-10 - Manual

INSTALL INSTRUCTIONS C-TCB-10
1996-2006 FORD TAURUS
TOOLS REQUIRED:
3/16” Allen wrench
3/8” Standard Socket Set
3/8” Metric Socket Set 3/8” Ratcheting Wrench
Powered drill w/ drill bit set
Standard Open-end wrench set
HARDWARE:
QTY DESCRIPTION PART
#
1 Pole support assembly CM93071-10
1 Telescoping pole CM93072-1
1 Under floor plate CM93132
1 Lateral support brace CM93148
1 Side support brace CM93149
2 ¼-20 Nylock nut GSM30016
1 5/16-18 Nylock nut GSM30017
2 3/8-16 Nylock nut GSM30018
4 ¼” Flat washer GSM31005
1 5/16” Flat washer GSM31006
5 3/8” Flat washer GSM31007
2 ¼-20 x ¾” Hex head bolt GSM33001
2 3/8-16 x ¾” Hex head bolt GSM33027
1 3/8-16 x 1 ¼” Hex head bolt GSM33029
Always
!
Read all instructions before installing any Havis-Shields Equipment Corp products.
Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes!
Use hardware provided with install kit
SUB ASSEMBLY:
1. Confirm receipt of all hardware and components.
2. Remove front passenger seat base trim.
INSTALLATION:
1. MOUNT POLE SUPPORT ASSEMBLY:
• Align pole support assembly’s slotted hole with similar slot on seat base and loosely
attach using 3/8-16 x ¾” bolt, washer and nut.
• Loosely attach smaller slot on assembly to seat base using ¼-20 x ¾”
• Repeat these processes attaching the side support brace to passenger seat base.
• Now loosely attach the side support brace and lateral (forward) support base to pole
assembly using 5/16” Nylock nut.