HP DV6 - Manual (Page 83)

7. Remove the two Phillips PM2.5×3.5 screws (1) that secure the TouchPad button board to
the top cover.
8. Remove the TouchPad button board (2).
Reverse this procedure to install the TouchPad button board.
Solid-state drive
Description Spare part number
160-GB solid-state drive for use on all computer models 682098-001
32-GB solid-state drive for use only on computer models equipped with an Intel processor 682099-001
Before removing the solid-state drive, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see Battery on page 51 ), and then remove the following components:
a. Hard drive (see Hard drive on page 52 )
b. Optical drive (see Optical drive on page 59 )
c. Keyboard (see Keyboard on page 61 )
d. Top cover (see Top cover on page 66 )
Component replacement procedures 75