Husqvarna 143R-II - Manual (Page 12)

ASSEMBLY
12 – English
Fitting the main body
Connect the engine (A) to the tube (B) with four screws
(C).
Assembling the handlebar and
throttle
• Fit the handlebar in the handlebar clamp on the shaft
using four screws.
• Attach the cabling to the shaft with two cabling
holders.
Make sure that the suspension ring and the handlebar
clamp are located in the area indicated by the arrow
labels. If they are moved outside of this area, it can cause
the machine to be imbalanced, which can be dangerous.
(A) Arrow labels
Connecting throttle cable and
stop switch wires
1 Remove the air filter cover.
2 Insert the throttle cable (A) to the end of the adjuster
(B).
3 Position the slotted fitting (C) on the carburettor so the
recessed hole (D) for the cable lug (E) is away from
the cable adjuster sleeve.
4 Rotate the carburettor throttle cam and slip the throttle
cable through the slot in the slotted fitting, making
sure the cable lug drops into the recessed hole.
5 Operate the throttle trigger a few times to make sure
that it works correctly.
6 Adjust the cable adjuster sleeve so the stop on the
carburettor throttle cam just contacts the throttle stop
A