Hayward Pools XSTREAM ISCC100 - Manual (Page 5)

X Stream™ Filtration Series _________________________
General Information
Introduction
This manual contains information for the proper installation and operation of the Hayward ® X Stream™ Filtration
Series. All X Stream™ Filtration models are high performance, above-ground swimming pool filters. Instructions in
this manual MUST be followed precisely.
Product Features
ƒ Engineered for easy use with flexible or rigid plumbing.
ƒ Sleek, flush mounted pressure gauge.
ƒ Extra large dirt capacity.
ƒ Quick release, high capacity air relief valve.
ƒ Glass reinforced, non-corrosive Permaglass XL™ filter tank will provide years of trouble-free operation.
ƒ Easy-Lok™ ring design allows quick access to all internal components in a single turn.
Installation Instructions
Filter Location
Set the filter on firm, level ground. Select a well-drained
area, one that will not flood when it rains. Position the filter
so that it may drain by gravity. The tank should be
positioned for easy access to the internals, pressure gauge,
and air relief valve.
Plumbing
To facilitate servicing of the filter system and to allow for
indoor storage during the winter months, installing union connections at the suction and outlet ports is recommended.
Use Teflon tape to seal threaded connections on molded plastic components. All plastic fittings must be new or
thoroughly cleaned before use. NOTE: Do NOT use Plumber’s Pipe Dope as it may cause cracking of the plastic
components. When applying Teflon tape to plastic threads, wrap the entire threaded portion of the male fitting with
one to two layers of tape. Wind the tape clockwise as you face the open end of the fitting, beginning at the end of the
fitting.
The pump suction and outlet ports have molded-in thread stops. Do NOT attempt to force hose connector fitting past
this stop. It is only necessary to tighten fittings enough to prevent leakage. Tighten fitting by hand and then use a tool
to engage fitting an additional 1 ½ turns. Use care when using Teflon tape as friction is reduced considerably; do
NOT over-tighten fitting or you may cause damage. If leaks occur, remove connector, clean off old Teflon tape, re-
wrap with one to two additional layers of Teflon tape, and re-install connector. Use 1 ½” I.D. flexible plastic pipe
with hose adapter fittings and hose clamps. If rigid PVC is used, be sure to install Hayward SP1500UNPAK2 union
connectors for easy servicing.
All plumbing connections on the X Stream™ Filter are 1 ½” N.P.T. When making connections, use plastic male-end
adapters. Apply three (3) turns of Teflon tape or plastic pipe sealant to the male threads. Screw the fitting into the
thread hand-tight; then using a wrench, tighten one more full turn, if necessary. (NOTE: Adapters have varying
tolerances and over-tightening with a wrench may only cause damage to the filter.) Ball type valves are recommended
where needed.
Connect the pool suction plumbing between the skimmer and the pump. Connect the pool return plumbing to the
OUTLET port at the bottom of the filter body.
A filter drain or plug is furnished with each filter and is all that is needed for complete filter draining. A manual air
relief valve is furnished to aid in the bleeding of unwanted air when starting or draining the filter.