Hunter Fan ARCHITECT 90061 - Manual (Page 5)

B11
D
5/8
1/2
5/8
1/2
B12
Slide the mounting rails into brackets.
Position the correct depth mark at the bottom edge of
the joist based on the thickness of your sheetrock.
E
B13
1/8" Bit
B14
Mark position of screws by using holes as a template.
Drill a hole in the center of each outline.
Pull wires through the strain relief.
Connect wires as shown.
A
A A
Green
Black White
Bare Copper
Ground
B19
B
D
B18
Tighten screws.
B17
Attach the rails onto the screws.
Insert screws, leaving space between the screw
head and the joist. Screws are not provided.
B15 B16
New Construction – suspended between joists
8
9
B20
2
F
F
1
•
B21
2
G
Install the wiring cover plate. Make sure all
wiring connections are inside the box or under
the wiring cover plate.
Tighten the wiring cover plate screw.
B22
Connect 4” duct and vent to the outside. Tape joints.
If ducting does not fit securely, an adapter may need
to be purchased.
41721-01 12/25/2004 41721-01 12/25/2004