Honeywell TE329ELW - Manual (Page 7)

If this does not work, please perform the following steps:
1. Bring the main unit and remote sensor close together.
2. Remove 4 a small screws from the back of the remote
sensor and open the battery compartment.
3. Remove the batteries from the battery compartment and
reinstall them in the same manner. Remote sensor LED
indicator will flash showing transmission of the signal.
4. Remove the batteries from the main unit and reinstall
them in the same manner.
5. On the main unit select the same channel number that
set on the remote sensor. Outdoor temperature on the
display will show that transmission is being received
successfully.
Note: When the temperature falls below the freezing point
the batteries in the remote sensor(s) will freeze
lowering their voltage output and effective range.
During prolonged periods of extreme cold it is
advisable to bring the remote sensor indoors, if
alkaline batteries are being used. We recommend
to use lithium ion batteries at temperatures below 32˚F.
TRANSMISSION COLLISION
Signals from other household devices, such as door bells,
home security systems and entry controls, may interfere
with this product and cause temporary reception failure.
This is normal and does not affect the general performance
of the product. The transmission and reception of the
temperature readings will resume once the interference ends.
CHECKING REMOTE AND
INDOOR TEMPERATURE
The indoor temperature is shown on the third line of the
main unit display. The remote temperature is shown below
the top line of the display. The wave icon near the remote
temperature reading indicates that there is a good signal
reception from the remote sensor.
USING THE ALARM AND SNOOZE
When the alarm sounds, press the LIGHT/SNOOZE key
to temporarily stop the alarm. After depressing LIGHT/
SNOOZE , the alarm sound will resume in 5 minutes. If the
alarm is not disabled after that, it will sound for 4 more
minutes and then will stop by itself.
Press ALARM ON/OFF to disable any alarm.
DISABLING ATOMIC TIME
SIGNAL RECEPTION
The main unit can be set manually to disable the daily
reception of the WWVB time signal.
Press and hold the and buttons at the same time for
3 seconds and the radio reception icon will disappear.
To enable the main unit’s ability to receive the WWVB
time signal, press and hold the and buttons at the
same time for 3 seconds again. The radio reception icon
will turn on and flash. The main unit will start to search
for the WWVB time signal immediately.
LOST COMMUNICATION
If the main unit display for the remote sensor goes blank,
press and hold for 3 seconds to begin a new signal
search. If the signal still isn't received, please make sure that:
1. The remote sensor is in its proper location.
2. The distance between the main and remote units is not
over 100 feet.
3. The path between units is clear of obstacles.
Shorten the distance between units if necessary.
4. Fresh batteries are installed correctly in both remote
sensor and main unit.