Heath Zenith 5718 - Manual (Page 5)

5 598-1308-02
SPECIFICATIONS
Range . . . . . . . . . . . . Up to 70 ft. (21 m); 100 ft.
(30.5 m) with Range Boost. [varies
with surrounding temperature]
Sensing Angle . . . . . . Up to 270°
Electrical Load . . . . . . Up to 300 Watt Maximum In-
candescent [Up to 150 Watt
maximum each lamp holder]
OR
Up to 60 Watt Maximum PAR
SBCFL [Up to 30 Watt maximum
each lamp holder].
Power Requirements . 120 VAC, 60 Hz
Operating Modes . . . . TEST, AUTO and MANUAL
MODE
Lamp Modes . . . . . . . Normal, Soft, Flash
Time Delay . . . . . . . . 1, 5, 20 minutes
D
ual
B
rite
® Timer . . . . 3, 6 hours, Dusk-to-Dawn
HeathCo LLC reserves the right to discontinue prod-
ucts and to change specifications at any time without
incurring any obligation to incorporate new features
in products previously sold.
TROUBLESHOOTING GUIDE
SYMPTOM POSSIBLE CAUSE
Lights will not come on. 1. Light switch is turned off.
2. Flood light is loose or burned out.
3. Fuse is blown or circuit breaker is turned off.
4. Daylight turn-off is in effect (recheck after dark).
5. Incorrect circuit wiring, if this is a new installation.
6. Re-aim the sensor to cover desired area.
Lights come on in daylight. 1. Light control may be installed in a relatively dark location.
2. Light control is in Test. (Set control switch to an ON-TIME position).
Lights come on for no ap-
parent reason.
1. Light control may be sensing small animals or automobile traffic (re-aim sensor).
2. Range is set too high. (Reduce Range).
3. D
ual
B
rite ® Timer is on.
Lights turn off too late in
Dusk-to-Dawn setting
1. Sensor is in a relatively dark location. (Relocate sensor, or use 3 hr or 6 hr setting.)
Lights stay on
continuously.
1. A flood lamp is positioned too close to the sensor or pointed at nearby objects that
cause heat to trigger the sensor. (Reposition the lamp away from the sensor or nearby
objects).
2. Light control is pointed toward a heat source like an air vent, dryer vent, or brightly-painted
heat-reflective surface. (Reposition sensor. Reduce Range).
3. Light control is in Manual Mode. (Switch to Auto.)
Lights flash on and off. 1. Heat or light from the lamps may be turning the Light control on and off. (Reposition
the lamps away from the sensor).
2. Heat being reflected from other objects may be affecting the sensor. (Reposition sen-
sor).
3. Light control is in the Test mode and warming up. (Flashing is normal under these
conditions. Turn Boost off.)
4. Light may be leaking through the floodlamp reflectors. (Replace the lamps with new high
quality PAR 38 lamps or make sure the metal lamp protectors are installed).
5. Light control is in Flash mode. (Flashing is normal in this mode. Select Normal or Soft
mode to turn flash mode off).
Lights flash once, then stay
off in Manual Mode.
1. Sensor is detecting its own lights. (Reposition lamps to keep area below the sensor
relatively dark.)