Harbor Freight Tools 44829 - Manual (Page 4)

SKU 44829 Page 4 REV 04/02
Warning: The warnings, cautions, and instructions discussed in this instruc-
tion manual cannot cover all possible conditions and situations that may oc-
cur. It must be understood by the operator that common sense and caution
are factors which cannot be built into this product, but must be supplied by
the operator.
Unpacking
When unpacking, check to make sure the parts listed on page 6 are included.
If any parts are missing or broken, please call Harbor Freight Tools at the num-
ber on the cover of this manual.
Operation
Note: Steel Capacity Cutting Chart found on page 5 of this manual.
Warning: This Cut-Off Saw is designed to cut iron metal. Do not cut wood, brick,
aluminum, or magnesium; tool damage and/or personal injury could occur.
Before using the saw always check the following:
A. Make sure the blade (not included) is securely attached.
Loosen Screw (#110) and lift Small Cover (#109) out of the way.
Warning! Unplug the power cord while setting up the saw and workpiece. Do not
plug in until ready to cut.
Using the Wrench (#91), remove the Hex Screw (#23) - reverse thread, Stop
Washer (#22), Flat Washer #21), and the Flange (#20). Set the blade on the
arbor and replace the hardware. Do not overtighten. Move Small Cover (#109)
back in place and tighten Screw (#110).
B. Check that the Upper Shield (#12) and Lower Shield (#30) are in place.
C. The Cut Off Saw must be located on a level, flat, workbench that is solid and
able to support the weight of the tool and workpieces. The workpiece must be
secured in a vise or with clamps (vise assembly included).
D. Always wear ANSI approved impact safety goggles.
1. Disconnect the Chain (#72), allowing the blade assembly to lift. The chain is
only used for transporting the tool. Make sure the saw has cooled for 3-5 minutes
before latching or unlatching the Chain (#72), to avoid burning yourself on the hot
blade.
2. Loosen the Vise (#82) on the vise assembly and position workpiece. Tighten
the Vise (#82).
3. Make sure the blade is clear to rotate freely.
4. Press the power Switch (#33). Allow blade to reach full speed.
5. Lower the Handle (#35) slowly and contact the workpiece with very little
pressure. Let the blade do the work. If the blade begins to slow, back off as you
are exerting too much pressure.
Caution: The Lower Shield (#30) and Small Cover (#109) must always be in
place. Both of these blade guards must be in place when the tool is being used.
6. Turn off the power and unplug the tool before removing workpiece. Never leave
the tool running unattended.