Hasselblad H1 - Manual (Page 7)

H1 IMPRINT MODE
www.hasselblad.com
Magazine settings
The last setting is to check that the magazine is programmed to imprint
data. This is the default setting of the magazine. Check that the caption
“DATA” is shown on the magazine LCD. If this is not the case, slide the
lock switch (4) on the right side of the magazine forward to unlock the
magazine buttons. Press the mode button (1) repeatedly until the cap-
tion “DATA” is shown together with “oFF”. Use either of the change but-
tons (2, 3) to change the indication to “on”. Press the rear button again.
Slide the lock switch backwards to lock the buttons again.
Magazine is correctly programmed
for data imprint as indicated by the
-icon at the top of the LCD
Magazine is programmed not to imprint
data
Press the button until the display shows
Press either of the buttons to change to ”on” and press the
again to store the change.
1 Mode button
2 Change down button
3 Change up button
4 Lock switch
Document ID: H1 imprint modes.indd - 2005-05-10