Honeywell HCC334L - Manual (Page 9)

Rev 3 4 G-113077-002
01/07
Eng
lish
Setting Up Your Camera
Figure 3 shows the factory set DIP switch settings.
Automatic Gain Control (AGC) and Auto White Balance
Control (AWC) are set ON.
Figure 3 Factory Set DIP Switch Settings
Selecting the Lens
Manual Lens
Set the EE/ME DIP switch on the rear of the camera (see
Figure 3 ) to EE. Set the AES/AI switch to AES. EE and AES
are the typical settings.
Vari-focal Auto Iris Lens
Vari-focal Auto Iris lenses (Direct Drive [DC] or Video Drive
[VSD]) are connected to the camera via a 4-pin square
socket located at the side of the camera. Set the AES/AI DIP
switch to AI. EE and AI are the typical settings.
To set a different exposure, see Exposure Mode on page 5 .
Direct Drive (DC) Lens
1. Set the VSD/DC switch on the rear of the camera to DC.
Set the AES/AI DIP switch to AI.
EE
AES
OFF
OFF
OFF
OFF
OFF
OFF
ME
AI
BLC
FL
AGC
WB3
WB2
WB1
VSD
DC
IRIS
LEVEL
- +
PUSH
LOCK IRIS
LEVEL
V-PH
PWR
VIDEO
L/L
INT
VSD
DC
ME
AI
BLC
FL
AGC
WB3
WB2
WB1 EE
AES
OFF
GND DC 12V
AC 24V
= ON
= OFF