Adjustments, Programming summary chart – Hubbell Electric Heater Company TI984 User Manual

Page 14

Advertising
background image

P

AGE

13 of 14

M

ODEL

TI984 T

ELEPHONE

I

NTERFACE

42004-071F

f:\standard ioms - current release\42004 instr. manuals\42004-071f.doc
05/03

Adjustments

The inside front cover of the TI984 contains 3 potentiometers to adjust audio levels. Use a small standard
screwdriver to adjust the page line level. Before adjustments are made, turn the Party Line Level
potentiometer fully counterclockwise and the Page Line Level potentiometer approximately one-half of
its travel. Use an outside telephone to establish communications through the TI984 with the GAI-Tronics
paging system. Once the incoming call is connected to the page line, adjust the Page Line Level
potentiometer until the volume level of the incoming page is approximately equal to a page made within
the system.

After the page level is adjusted, pick up the incoming call at a station near the TI984. When
communications are established, adjust the Sidetone Adjust potentiometer on the TI984 for minimum
sidetone on the GAI-Tronics station. Sidetone is the amount of signal transmitted from the microphone to
the receiver. To complete this adjustment, blow into the microphone at the station while adjusting the
potentiometer on the TI984 for minimum signal in the ear piece of the station. As the potentiometer is
adjusted, the signal will decrease (null), then increase.

After the sidetone adjustment is completed, adjust the Party Line Level potentiometer until the level of
the signal from the telephone line is comparable to the level of a signal within the system.

If all adjustments are made properly, pages from the TI984 will be the same volume as pages from a
Page/Party

®

station. Party line adjustment should be tested from a Page/Party

®

station. When properly

set, this communication with an outside call will sound like communication with another station.

Programming Summary Chart

Description

Factory Setting

for Day Mode

Factory Setting

for Night Mode

User

Programming

Incoming Call Mode

Voice Access Method

Ring Access Method

Voice Page Duration

7 seconds

Not applicable with unit
in Ring Access Method

Page to Answer Duration

60 seconds

Not applicable with unit
in Ring Access Method

Auto-connect Option

Enabled

Not applicable with unit
in Ring Access Method

Incoming Rings

4

1

Hang-up Delay

7 seconds

7 seconds

Day/Night Switch

Internal

Internal

Advertising