Hearth and Home Technologies Cinch Pipe & Termination Cap System - Manual

Hearth & Home Technologies Inc. • Cinch Pipe & Term Caps • 4033-900 Rev K • 05/05 1
TM TM
Models:
Cinch Pipe & Termination Cap System
Installation
Instructions
If you need assistance during installation, contact your local dealer or the Technical Serices Dept., Hearth & Home Technologies
Inc., phone 1-800-927-6841 or 1-888-427-3973.
Note: An arrow ( ) found in the text signifi es change in content.
Sharp Edges
• Wear protective gloves and safety glasses
during installation.
CAUTION
These instructions are replacing VP (for Heatilator) and DV (for Heat-N-Glo) pipe assembly
instructions. See the appliance installation instructions for confi guration of vent assembly
and clearances to pipe.
If DVP-AD adapters are used off the top of the appliance, the termination height will be raised by 2-3/4 in. overall
height.
Hearth & Home Technologies disclaims any
responsibility for, and the warranty will be
voided by, the following actions:
• Installation and use of any damaged vent
system component.
• Modifi catoin of the vent system.
• Installation other than as instructed by
Hearth & Home Technologies.
• Installation and/or use of any component
part not approved by Hearth & Home
Technologies.
Any such action may cause a fi re hazard.
WARNING
Do not mix pipe, fittings or joining
methods from different manufacturers.
WARNING