Heath Zenith LED Lighted Pushbutton with Courtesy Light 598-1189-01 - Manual (Page 2)

 598-1189-01
1. Attach the two wires from your chime
and transformer to the screw terminals
on the back of your pushbutton (see
Figure 1). Press pushbutton to test
function.
2. If your chime functions correctly and
plays the entire tune, skip to step 7. If
your chime does not function correctly,
proceed with step 3.
Figure 1 - Attach Chime Wires to
Pushbutton (Back of Pushbutton Shown)
UP
JUMPER POSITION
SEE OWNER’S MANUAL
FOR DETAILS
MECHANICAL CHIME
ELECTRONIC CHIME
Wires from Chime and
Transformer
Screw
Terminals
Orientation
Marking
Mounting Holes
Installation
IMPORTANT: DO NOT install additional
diode(s) to pushbutton. Additional diode(s)
will cause chime to malfunction.