HP 39gs - Manual (Page 271)

Extending aplets 19-5
To transmit
an aplet
1. Connect the PC or aplet disk drive to the calculator by
cable
or
align the two calculators’ infrared ports by matching
up the triangle marks on the rims of the calculators.
Place the calculators no more than 4 inches (10 cm)
apart.
2. Sending calculator: Open the Library, highlight the
aplet to send, and press .
– The
SEND TO menu appears with the following
options:
HP39G (IRDA) = to send via high-speed infrared
HP39/40 (USB) = to send via the USB port
HP39/40 (SER)
= to send via the RS232 serial port
USB DISK DRIVE
= to send to a disk drive via the USB
port
SER. DISK DRIVE
= to send to a disk drive via the
RS232 serial port
Note: choose a disk drive option if you are using
the hp39gs connectivity kit to transfer the aplet.
Highlight your selection and press .
– If transmitting to a disk drive, you have the
options of sending to the current (default)
directory or to another directory.
3. Receiving calculator: Open the aplet library and
press .
– The
RECEIVE FROM
menu appears with the following
options:
HP39G (IRDA)
= to receive via high-speed infrared
HP39G = to receive via low-speed infrared
HP39/40 (USB) = to receive via the USB port
HP39/40 (SER)
= to receive via the RS232 serial port
USB DISK DRIVE
= to receive from a disk drive via the
USB port
SER. DISK DRIVE
= to receive from a disk drive via the
RS232 serial port
HP 39gs English.book Page 5 Wednesday, December 7, 2005 11:24 PM