Hamilton Beach 840124300 - Manual (Page 4)

7 6
To Steam Iron
1. With travel iron/steamer unplugged, press Handle Release
Button and rotate handle 180 degrees until it locks and is
parallel or “in line” with travel iron/steamer body.
2. Remove Water Tank Plug. Using Water Cup, slowly pour 2
ounces (60 ml) of tap water into Water Tank Opening.
Replace Water Tank Plug.
3. Make sure dual voltage selector switch is set to correct
voltage and then plug travel iron/steamer into power supply.
4. Turn Temperature Control Dial to Steam . With travel
iron/steamer resting on side position, allow three minutes
for travel iron/steamer to reach desired temperature.
Do not preheat travel iron/steamer with soleplate facing
down.
5. Press Steam Button to generate steam to travel iron/steamer.
6. To turn travel iron/steamer off, turn Temperature Control
Dial to OFF (O).
7. Unplug travel iron/steamer. Empty water from the travel
iron/steamer following directions in “Caring for your travel
iron/steamer.”
8. Allow to cool completely before returning handle to
storage position and placing travel iron/steamer in
storage bag.
To Steam Brush
1. With travel iron/steamer unplugged, press Handle Release
Button and rotate handle 180 degrees until it locks and is
parallel or “in line” with travel iron/steamer body.
2. Remove Water Tank Plug. Using Water Cup, slowly pour
2 ounces (60 ml) of tap water into the Water Tank Opening.
Replace Water Tank Plug.
3. Slide Brush Attachment over soleplate. Rotate Brush
Attachment Lock 180 degrees.
4. Make sure dual voltage selector switch is set to correct
voltage and then plug travel iron/steamer into power supply.
5. Turn Temperature Control Dial to Steam . With travel
iron/steamer resting on side position, allow three minutes
for travel iron/steamer to reach desired temperature.
Do not preheat travel iron/steamer with soleplate facing
down.
6. Clothing should be on a hanger. Pull fabric taut. Hold
steamer upright against fabric. Press Steam Button
every three seconds for steam.
NOTE: The Steam Brush may be used as a lint remover.
If using on delicate fabric that may snag, remove Brush
Attachment by pulling straight up after unlocking Brush
Attachment lock prior to heating travel iron/steamer.
7. To turn travel iron/steamer off, turn Temperature Control
Dial to OFF (O).
8. Unplug travel iron/steamer. Empty water from the travel
iron/steamer following directions in “Caring for your travel
iron/steamer.”
9. Allow to cool completely before returning handle to storage
position and placing travel iron/steamer in storage bag.
840124300 ENv02.qxd 3/16/04 9:28 AM Page 6