Hunter Fan 31004 - Manual (Page 4)

4
44061-01 • 08/02/2010
initial Setup:
1. Remove the plastic bag covering from the humidifier.
2. Unravel and straighten the cord before use.
3. Remove the tank from the humidifier base by grasping the
tank handle, Figure 1, and pulling straight up. Figure 2.
4. Turn the tank upside down and twist the tank cap counter-
clockwise to remove. Figure 3.
5. Fill the unit with clean, cool tap water.
Warning:
Never fill the humidifier with hot water.
6. Place the tank cap back on the tank and turn it clockwise
until secure.
7. Seat the tank back into the humidifier base, making sure
the tank is seated securely.
nOte:
Failure to ensure the tank is seated correctly could
cause the unit to leak water from the tank.
8. Plug the humidifier into a wall outlet and start the unit.
Figure 1
Tank Handle
Figure 3
Tank Cap
ON/OFF
Water Level
Figure 2
ON/OFF
Water Level
Figure 4
Operation:
1. To turn the humidifier on, turn the humidity adjustment knob
clockwise until you feel the knob click. At this time the unit
should be on and you can adjust the amount of mist the
unit outputs by continuing to turn the knob clockwise. To
turn the unit off, turn the humidity adjustment knob counter-
clockwise until it clicks. Figure 4.
2. When the unit is out of water, the water level light will
illuminate.Figure 4.
3. Refilling the water tank and placing it securely back on the
base will turn this feature off. Figure 4.
Using Your Humidifier
Initial Setup and Operation
2