Operating instructions, Unpacking – Harbor Freight Tools 94724 User Manual
Page 10
SKU 94724
For technical questions, please call 1-800-444-3353.
Page 10
OPERATING INSTRUCTIONS
NOTE: For additional information regarding the parts mentioned in the following pages,
refer to the Assembly Diagrams on pages 14 and15.
1.
IMPORTANT! Always fill the Air Compressor with a premium quality,
30-weight, non-detergent, compressor oil before each use. Running the Air
Compressor with no oil or low oil will cause damage to the equipment and
void the warranty. To check the level of oil, make sure the Air Compressor is
OFF. Then, observe the Oil Sight Gauge (19). The level of oil should just reach
UNPACKING
When unpacking, check to make sure all the parts shown on the Parts Lists on pages 14
and 15 are included. If any parts are missing or broken, please call Harbor Freight Tools at
the number shown on the cover of this manual as soon as possible. It may be necessary to
attach the Air Filter Kit (31). If so, remove the plastic cap on the receptacle. Then, screw the
Air Filter into the Cylinder Head (2).
22.
WARNING! The warnings, precautions, and instructions discussed in this
manual cannot cover all possible conditions and situations that may occur. The
operator must understand that common sense and caution are factors which
cannot be built into this product, but must be supplied by the operator.
23. WARNING! The brass components of this product contain lead, a chemical
known to the State of California to cause birth defects (or other reproductive
harm). (California Health & Safety code § 25249.5,
et seq.
)
FIGURE C
WATER
OILER
TO
AIR TOOL
TO:
AIR OUTLET
VALVE (48)