HSM Securio B32 - Manual (Page 11)

0804 11
english
5 Troubleshooting
Display Problem Measure
Paper
jam You have fed in too much paper.
The cutting unit runs in reverse for a few seconds and pushes the pa-
per back out again.
• If necessary, press the reverse button “R” to remove the stack of paper.
• Take half the stack of paper.
• Feed the paper in portions.
Note:
This indicator lamp also lights up when the motor is overloaded. In this
case, let the shredder cool down for 20 minutes before using it again.
Shredded
material
container
full • Empty the shredded material container.
Note:
If you press the reverse button briefl y before opening the door, part of
the material is pulled back into the cutting apparatus.
Door
open • Close the front door.
Other function modes:
• Brief mode 10 s
Application: Shredding foils, credit cards and
small bits of paper
Function: The cutting unit runs for approx.
10 seconds and is then switched off auto-
matically.
Start: Press the operation button for two
seconds.
Premature cancellation: Press the operation
button.
• Permanent mode
Application: Shredding CDs and large quanti-
ties of paper and foils
Function: Cutting unit runs continuously.
If no material is fed in within a period of
2 minutes, the cutting unit shuts down and
the shredder switches to standby.
Start: Press the operation button for four
seconds.
Premature cancellation: Press the operation
button.
• Sleep mode
Function: Two minutes after the last paper
feed operation, all consumers that are not
required are switched off automatically.
The "Ready for operation" indicator fl ashes
briefl y at regular intervals.
The shredder starts automatically when pa-
per is fed in.
• Automatic shutdown
Function: If the shredder is not used for four
hours, it shuts down completely and there-
fore does not consume any more electricity
(at night, at the weekend).
Restart: Press the operation button.