Hawking Technology HWPS1UG - Manual (Page 71)

following BOOTP configuration. To rebuild the NIS map,
please refer to your system documentation.
To configure the IP address data for the BOOTP server, you
will need to log in as the host of the BOOTP server with
superuser (root) admin rights. Perform the following steps to
add address entries:
1. Optionally, assign a name corresponding to the print
server’s IP address. You can add this address to the /etc/hosts
file, by adding the following line:
203.66.191.12 pserver
2. Add an entry to the host’s /etc/bootptab file, similar to the
following:
hostname:\
:ht=1:\
:ha=print_server_ethernet_address:\
:ip=print_server_ip_address:
Lines should be indented with tabs.
Where hostname is the device name of the HWPS1UG ; the ht=1
tag specifies that the hardware type is Ethernet. The ha= tag
specifies that the Ethernet address of the HWPS1UG is the
Node ID located on the print server. The ha tag must be
preceded by the ht tag. The ip= tag should correspond to the IP
address you want to assign to the print server.
For example, below is an example of a print server with the
following configuration: