Husqvarna 1330SB-XLSB - Manual (Page 21)

21
REPAIR PARTS
AUGER HOUSING / IMPELLER ASSEMBLY
SNOW THROWER - MODEL NO. 1330SB-XLSB (96193004100), PRODUCT NO. 961 93 00-41
NOTE: All component dimensions given in U.S. inches. 1 inch = 25.4 mm
IMPORTANT: Use only Original Equipment Manufacturer (O.E.M.) replacement parts.
Failure to do so could be hazardous, damage your snow thrower and void your warranty.
KEY PART
NO. NO. DESCRIPTION
1 532 18 41-05 IMPELLER
2 532 19 67-10 GEARBOX ASSEMBLY
3 532 18 89-09 BEARING
4 532 19 10-79 IMPELLER PULLEY
5 532 17 53-22 DISCHARGE BASE
6 532 18 40-95 CORNER BRACKET
7 532 19 21-99 CLEAN OUT TOOL
8 532 40 54-00 TOOL CLIP
9 873 80 04-00 NUT 1/4−20
10 874 78 04-26 SCREW 1/4−20 X .625
11 532 15 53-77 NUT 5/16−18
12 532 16 31-83 SCREW 5/16−18 X .625
13 819 11 15-07 WASHER
14 810 04 05-00 LOCKWASHER 5/16
15 874 94 05-16 SCREW 5/16−18 X 1.00
16 532 18 03-55 CARRIAGE BOLT
17 532 19 41-89 SCREW 13−16 X .625
18 532 40 77-60 PLUG
19 532 40 77-61 GEARBOX COVER RH
20 532 40 77-66 GASKET
21 532 40 77-70 SEAL
22 532 40 77-62 BEARING
23 532 17 46-97 THRUST WASHER 1.00
24 532 40 77-63 WORM GEAR
25 532 40 77-64 AUGER SHAFT
26 532 18 92-82 SQUARE KEY
27 532 40 77-58 BEARING
28 532 17 46-83 THRUST WASHER
29 532 40 77-57 IMPELLER SHAFT
30 532 18 42-05 ROLL PIN
31 532 17 46-81 THRUST WASHER
32 532 17 46-84 THRUST BEARING
33 532 40 77-69 BEARING
34 532 40 77-68 O−RING
35 532 40 77-67 SCREW 5/16−18 X .750
36 532 40 77-65 GEARBOX COVER LH