Harbor Freight Tools 9592 - Manual (Page 5)

UNPACKING
When unpacking, check to make sure all the parts shown on the Parts List on page 9 are
included. If any parts are missing or broken, please call Harbor Freight Tools at the num-
ber shown on the cover of this manual as soon as possible.
ASSEMBLY INSTRUCTIONS
NOTE: For additional references to the parts mentioned in the following pages, refer to
the Assembly Diagram on page 10.
SKU 09592 PAGE 5
To Attach The Air Compressor Pump To A Mounting Surface:
1. NOTE: Depending on your level of assembly expertise, you may wish to have a
qualified technician perform the assembly procedures.
2. CAUTION: Make sure the mounting surface (air compressor stand, work-
bench, etc.) to which the Air Compressor Pump will be attached is flat, level, and
sturdy enough to withstand the weight of the Air Compressor Pump and all other
necessary equipment and accessories.
3. At the base of the Air Compressor Pump are four 3/8” mounting holes with a hole
pattern of 5-1/2” long by 7-1/2” wide. If four 3/8” mounting holes with a hole
pattern of 5-1/2” long by 7-1/2” wide do not already exist in the mounting surface,
it will be necessary to drill the
four 3/8” mounting holes through the mounting
surface. IMPORTANT: Prior to drilling, make sure there are no electrical cables,
wires or other obstructions in the drilling path. (See Figure A.)
4. To do so, temporarily position the Air Compressor Pump in the desired location
on the mounting surface. Use the base of the Air Compressor Pump, with its four
3/8” mounting holes, as a template by which to mark the four 3/8” mounting holes
that are to be drilled through the mounting surface. Then, remove the Air Com-
pressor Pump from the mounting surface. NOTE: You may also follow the illus-
tration below by which to measure where each of the four 3/8” mounting holes
should be drilled. (See Figure A.)
5-1/2”
7-1/2”
FIGURE A BASE OF AIR COMPRESSOR PUMP
BOTTOM VIEW
PULLEY
(#38)