Harbor Freight Tools 96329 - Manual (Page 3)

Page 3 96526/27/28 For technical questions, please call 1-800-444-3353.
unpacking
When unpacking, check to make sure that the item is intact and undamaged. If
any parts are missing or broken, please call Harbor Freight Tools at the number shown
on the cover of this manual as soon as possible.
asseMbly
There is no assembly required for this Garage Threshold.
installation instructions
read the entire iMportant saFety inForMation section at the
beginning of this manual including all text under subheadings therein
before set up or use of this product.
Fitting and installing the threshold
Open the garage door and clean the bottom of the door and the area of the
garage floor where the door and the floor meet. Make sure there is no moisture
or dirt on the surface or you will not get a good bond with the Threshold.
Place the Threshold in the opening, centering it between the door tracks on
each side of the entrance. The garage door tracks are the channels the door
uses as it rolls up and down. The Threshold is made to fit most garage doors so
usually no trimming is necessary. If you do have to trim, use a straight edge for a
uniform fit when the Threshold is installed.
Figure 1
45° Angle
Garage Door (Down)
Garage Door Threshold
Lower the door onto the Threshold. Place the 45° angle of the Threshold against
the inside of the bottom of the door. The 45° angle of the Threshold should be
against the inside of the door for a proper seal against moisture.
Trace the inside edge of the Threshold then raise the garage door and, using a
carpenters pencil (not included), trace the leading edge of the Threshold.
1.
2.
3.
4.