Healthrider HRTL16940 - Manual (Page 25)

25
PROBLEM SOLUTION
a. Make sure that the power cord is plugged into a surge suppressor, and that the
surge suppressor is plugged into a properly grounded outlet (see page 8). Use
only a single-outlet surge suppressor that meets all of the specifications described
on page 8. Important: The treadmill is not compatible with GFCI-equipped outlets.
b. Make sure that the key is fully inserted into the console.
c. Check the reset/off circuit breaker located on the
treadmill frame near the power cord. If the switch
protrudes as shown, the circuit breaker has tripped.
To reset the circuit breaker, wait for five minutes and
then press the switch back in.
a. Check the reset/off circuit breaker located on the treadmill frame near the power
cord (see 1. c. above). If the circuit breaker has tripped, wait for five minutes and
then press the breaker back in.
b. Make sure that the power cord is plugged in. If the power cord is plugged in, un-
plug it, wait for five minutes, and then plug it back in.
c. Remove the key from the console and then reinsert it.
a. Use only a single-outlet surge suppressor that meets all of the specifications de-
scribed on page 8.
b. If the walking belt is overtightened, tread-
mill performance may decrease and the
walking belt may be permanently dam-
aged. Remove the key and
UNPLUG THE
POWER CORD. Using the included allen
wrench, turn both rear roller adjustment
bolts counterclockwise 1/4 of a turn.
When the walking belt is properly tight-
ened, you should be able to lift
the edges
of the walking belt 3 to 4 inches off the
walking platform. Be careful to keep the
walking belt centered. Plug in the power cord, insert the key and run the treadmill
for a few minutes. Repeat until the walking belt is properly tightened.
1. The power does not
turn on
2. The power turns off
during use
3. The walking belt
slows when walked
on
TROUBLESHOOTING
Most treadmill problems can be solved by following the instructions below. If further assistance is
needed, please call our Customer Service Department toll-free at 1-800-999-3756, Monday through Friday,
6 a.m. until 6 p.m. Mountain Time (excluding holidays).
Reset Tripped
c
Rear Roller Adjustment Bolts
b
3–4”