haier HWM90-98 - Manual (Page 16)

START
TIME REMAINED(MINUTE)
RESERVE(HOURS LATER)
RESERVE
Push the "START/PAUSE" button
PAUSE
5 Close the top lid
6 Finish washing
After Finishing wash
alarm automatically
As the top lid opened ,the Washer will automatically give an alarm
and stop running , exclusively during supplying water and rinsing.
After finishing wash it'll switch off the power automatically.
Push the "reserve" button to select suitable reserve wash program
* Total time: including the normal water inlet time and drain time. The total washing time may be influenced by
the water inlet pressure and water level.
* Spin time: From the moment the intermittent spinning starts to the moment it stops running (the time displayed
on spin digitron is from intermittent spinning to the moment before inertia spinning; the time displayed on the
time remain digitron is the total remained time)
* In selecting "posthaste" program, the washing machine will set the complete procedures of water level
selectior, washing, rinsing and spinning automatically.
* During saving water program, if the water inlet pressure is lower, the machine will come into rinse with water .
* When selecting soak procedure, it will first soak for 10~40 minutes , then do washing , rinsing and spinning .
After switching on the power, the reserve program is set to off mode automatically. If you need to set the washing
procedure to be finished at reserved time, please push the " RESERVE " button to set the reserve wash program.
Refer to RESERVE button in Page 11 for selection.
When the "reserve" function is activated, the indicator light of the program you have set
will be off. The remained time will be displayed. During reserve procedure, push the
"RESERVE" button to display the reserve mode.
To change the running program or cancel the reserve setting, you
need to switch off the power and make new selection.
the washing will be finished after 18 hours.
Confirm the operation of reserve program
Page
Using process Using process
14