3 verify system starts and update software, Orizon, 5navmate® installation manual – Horizon Navigation NavMate Navigation System User Manual
Page 5
H
ORIZON
N
A
V
I
G
A
T
I
O
N
5
NavMate® Installation Manual
3.3 Verify system starts and update software
1) Make sure ignition is OFF.
2) Connect wire harness to controller and video cable to controller and display unit.
3) Turn on ignition.
4) Insert the CD-ROM into the controller. NavMate will update its software. DO NOT
TURN OFF THE IGNITION WHILE NAVMATE IS UPDATING.
5) Verify that NavMate powers-up correctly.
NOTE: The Display should be connected before power is turned on.
TABLE 2. Signal/Power
No.
Signal/Power
Wire Color
Requirements
Typical
location
1
Ground (battery minus)
Black
battery minus
Chassis
2
Reverse gear signal
Light Green
+13.8V DC nominal (when vehicle in reverse)
Low level voltage VL max: 1.0 VL (min.)
High level voltage VH min.: 7.0 VH (min.)
Backup
light
3
Ignition signal
Pink
+13.8V DC nominal (when ignition on)
Low level voltage VL max: 1.0 VL (min.)
High level voltage VH min.: 7.0 VH (min.)
Fuse
block
4
Vehicle speed signal
(sine wave)
Yellow
Input pulse frequency: ˜0Hz to 2.5 KHz
Input voltage range: -13 to +26 Vmax
Low level voltage VL max: 0.9 VL (max)
High level voltage VH min.: 4.0 VH (min.)
PCM
5
Vehicle speed signal
(square wave)
Green/White
Input pulse frequency: 1 Hz to 200 Hz
Input voltage range: -13 to +26 Vmax
PCM
6
Not used
-
-
-
7
Not used
-
-
-
8
Not used
-
-
-
9
Not used
-
-
-
10
Not used
-
-
-
11
Not used
-
-
-
12
Not used
-
-
-
13
Not used
-
-
-
14
Not used
-
-
-
15
Not used
-
-
-
16
System power source
(battery plus)
Red
+13.8 V DC nominal, 3 Amp (min.)
Fuse
block
10
12
15
14
13
11
9
2
3
4
5
6
7
8
16
1
CONTROLLER CONNECTOR
(WIRE HARNESS VIEW)