Making the electrical connections, Installing fan to the outlet box – Hampton Direct Altura 68-ATR User Manual
Page 7
5.
Figure 7
Figure 8
Motor Wires
Ball/Downrod
Assembly
Canopy
Canopy
Ring
Cover
Hanger
Pin
Locking
Pin
Motor
Collar
Motor Collar
Tighten
Screws
Pin in
Position
Locked
Reversing
Switch
Installing Fan to
the Outlet Box
WHEN MOUNTING THE FAN ON A SLOPED
CEILING, THE STANDARD BALL/DOWNROD
MOUNTING METHOD MUST BE USED. THE
MOUNTING PLATE MUST BE MOUNTED SO
THAT THE SLOT OPENINGS ARE ON THE
LOWER SIDE BY SLIDING THE MOUNTING
PLATE FROM THE TOP DOWN.
Install the ceiling mounting plate on the out-
2.
let box, by sliding the mounting plate over
the two screws provided with the outlet box
(Figure 8). If necessary, use leveling wash-
ers (not included) between the mounting
plate and the outlet box. Note that the flat
side of the mounting plate is toward the out-
let box (Figure 8).
Securely tighten the two mounting screws.
3.
Carefully lift the fan assembly up to the
4.
ceiling mounting plate. Make sure the tab
on the mounting plate is properly seated in
the groove in the hanger ball.
installed by a licensed electrician.
Follow the steps below to connect the fan
to your household wiring. Use the wire
connecting nuts supplied with your fan
and supplied with remote control. Se-
cure the connectors with electrical tape.
Make sure there are no loose strands or
connections (Figure 9).
Connect both green wires from the down-
1.
rod and mounting plate to the bare copper
(Ground) from the outlet box
Connect the black wire (AC IN L) from
2.
the receiver unit to the black wire from the
outlet box.
Connect the white wire (AC IN N) from
3.
the receiver unit to the white wire from the
outlet box.
Connect the white wire (To Motor N) from
4.
the receiver unit to the white wire from the
fan assembly.
Connect the black wire (To Motor L) from
5.
the receiver unit to the black wire from the
fan assembly.
After wires are connected, carefully tuck them
into the outlet box. Insert the receiver unit into
the mounting plate; make sure the black antenna
wire sits on top of the receiver unit.
Pass the 120-volt supply wires through the
1.
center hole in the ceiling mounting plate as
shown in Figure 8.
Making the Electrical
Connections
REMEMBER to disconnect the power. If
you feel you do not have enough electrical
wiring knowledge or experience, have your fan