Henkel K-1000 - Manual (Page 6)

CHANGING THE THERMOSTAT
1. Disconnect from the power source.
2. Remove cover plate from control box and disconnect wire connectors from thermostat leads.
3. Remove thermostat knob and chrome bezel. Remove thermostat from control box and pull sensing
bulb from oven wall
4. Place thermostat leads on new thermostat and insert sensing bulb through oven wall being sure there
is adequate length to reach holder.
5. Loosely attach thermostat and chrome bezel to control box. Place knob on thermostat and adjust
bezel so that knob turns freely. When knob turns freely, remove knob, tighten bezel, and replace and
tighten knob.
6. Rewire element leads as per wiring diagram and replace control box cover.
K-1000 M&T Wiring Diagram 120V / 250W 240V / 1000W