Heat & Glo Fireplace HEAT-N-GLO Glass Enclosure Kits: GD415ATPB and GD485ATPB EM-415 - Manual

1
690-950D 7/04
Glass Enclosure Kits: GD415ATPB and GD485ATPB
for Models: EM-415 and EM-485
- Installation and Operation Instructions -
Printed in U.S.A. Copyright 2004,
Heat-N-Glo, a brand of Hearth & Home Technologies Inc.
20802 Kensington Boulevard, Lakeville, MN 55044, USA
HEAT-N-GLO QUALITY SYSTEMS
REGISTERED BY SGS ICS
Figure 1
Contents of shipping carton:
(See Figure 1 for sheetmetal parts)
Qty. Part Item
1 Hinge: Bottom left .................................................. 1
1 Hinge: Bottom right ............................................... 2
1 Hinge: Top right ..................................................... 3
1 Hinge: Top left ....................................................... 4
2 Side Filler ............................................................ 5
1 Front Filler ........................................................... 6
2 Top/Bottom Tracks .............................................. 7
2 Ball Stud .............................................................. 8
2 Ball Stud Plate .................................................... 9
2 Ball Stud Receiver Bracket ................................ 10
2 Doors
2 Handles
4 3/4" Screws for Handles
4 Slotted Hinge screws
2 Nylon Washers
14 1/2" Sheetmetal screws
4 1/4" Screws for Ball Stud Receiver Bracket
4 Steel Washers
1
2
3
4
5
6
7
8
9
10
IMPORTANT: Read all instructions carefully before start-
ing installation. Failure to follow these installation in-
structions as detailed may result in a possible fire haz-
ard and will void the warranty.
INSTALLATION PRECAUTIONS
The Heat-N-Glo Glass Enclosure Kits GD415ATPB and
GD485ATPB are tested and safe when installed in accor-
dance with this installation manual. It is your responsibility
to read all instructions before starting installation and to
follow these instructions carefully during installation to as-
sure maximum benefit from and safe operation of the glass
enclosure.
These glass enclosures are fully engineered and must be
installed on Models EM-415 and EM-485 fireplaces. If you
modify it or any of its components, you may cause a fire
hazard and will void the warranty. In addition, such action
may void the coverage provided by the owner's home insur-
ance.
The glass enclosure must be installed WITHIN the fireplace
opening as detailed in these instructions . It must NOT be
separated from the firebox with fireplace facing or finishing
materials.
It is highly recommended the outside air kit AK22 is used.
It is good practice to protect your hands and eyes during
installation by wearing work gloves and safety glasses.
HOT! DO NOT TOUCH.
SEVERE BURNS MAY RESULT.
CLOTHING IGNITION MAY RESULT.
WARNING
Glass and other surfaces are hot during operation and
cool down.
• Keep children away.
• CAREFULLY SUPERVISE children in same room as ap-
pliance.
• Alert children and adults to hazards of high tempera-
tures.
• To avoid burns or clothing ignition, the doors must re-
main closed if children will be present during the opera-
tion and cool down of the fireplace.
• Do NOT operate with protective barriers open or re-
moved.
• Keep clothing, furniture, draperies and other combusti-
bles away.
CHECK CONTENTS OF SHIPPING CARTON
Compare contents in the following list with actual parts re-
ceived. If any parts are missing, or damaged, contact your
dealer before starting installation. Do not install a damaged
glass enclosure kit.